論文 - 横森　剛

Burning Velocity of Triple Flames with Gentle Concentration Gradient

Mitsutomo Hirota, Takeshi Yokomori, Kyouhei Yasuda, Yoshitaka Nagai, Masahiko Mizomoto, Goro Masuya

Proceedings of the Combustion Institute （Elsevier）  31   893-899 2006年08月

研究論文（学術雑誌）, 共著, 査読有り

超過エンタルピ燃焼を用いた小型燃焼加熱器（マイクロコンバスタ）の開発

加藤 壮一郎, 相墨 智, 横森 剛, 丸田 薫

日本燃焼学会誌 48 （ 145 ） 235-240 2006年

研究論文（学術雑誌）, 共著

Stability Limits of Swiss-roll Micro Combustors

Nam Il Kim, Souichiro Kato, Takeshi Yokomori, Takuya Kataoka, Shigenao Maruyama, Toshiro Fujimori, Kaoru Maruta

Thermal Science and Engineering 13 （ 4 ） 7-8 2005年10月

研究論文（学術雑誌）, 共著, 査読有り

Flame Stabilization and Emission of Small Swiss-roll Combustors as Heaters

Nam Il Kim, Souichiro Kato, Takuya Kataoka, Takeshi Yokomori, Shigenao Maruyama, Toshiro Fujimori, Kaoru Maruta

Combustion and Flame （Elsevier）  141   229-240 2005年05月

研究論文（学術雑誌）, 共著, 査読有り

Flame Synthesis of Carbon Nanotubes in a Wall Stagnation Flow

Shunpei Nakazawa, Takeshi Yokomori, Masahiko Mizomoto

Chemical Physics Letters （Elsevier）  403   158-162 2005年02月

研究論文（学術雑誌）, 共著, 査読有り

Flame Temperatures along a Laminar Premixed Flame with a Non-uniform Stretch Rate

Takeshi Yokomori, Masahiko Mizomoto

Combustion and Flame （Elsevier）  135   489-502 2004年12月

研究論文（学術雑誌）, 共著, 査読有り

Emission and Efficiency of Small Swiss-Roll Combustors as Heat Sources

Nam Il Kim, Souichiro Kato, Toshiro Fujimori, Takuya Kataoka, Takeshi Yokomori, Kaoru Maruta, Shigenao Maruyama

Thermal Science and Engineering 12 （ 4 ） 121-122 2004年10月

研究論文（学術雑誌）, 共著, 査読有り

Interaction of Adjacent Flame Surfaces on the Formation of Wrinkling Laminar Premixed Flame

Takeshi Yokomori, Masahiko Mizomoto

Proceedings of The Combustion Institute （Elsevier）  29   1511-1517 2002年08月

研究論文（学術雑誌）, 共著, 査読有り

• Access to Document (DOI)

しわ状に形成される層流予混合火炎の火炎温度

横森 剛, 溝本 雅彦

日本機械学会論文集（Ｂ編） （Japan Society of Mechanical Engineers）  67 （ 664 ） 3189-3195 - 3195 2001年11月

研究論文（学術雑誌）, 共著, 査読有り,  ISSN  0387-5016

　概要を見る

The flame temperature of a laminar premixed flame with continuous convex and concave curvatures was experimentally investigated. The flame temperature and the stretch rate along the flame surface were measured for the flame formed in the lean propane/air mixture (φ = 0.72, Lc = 1.74). As a result, the flame temperature at the convex toward the unburned mixture was lower than the adiabatic flame temperature and that of the concave was higher, because of the flame stretch and the Lewis number effect. However, the measured flame temperature was different from the estimated flame temperature by the theory for the local flame structure proposed by C. J. Sun et al. We guess the reason why such difference was arisen is the existence of the heat transfer along the flame surface, so we suggest that the heat transfer along the flame surface should be considered in the case of the flame with continuous convex and concave curvatures.

• Access to Document (DOI)