Papers - Matsuo, Akiko

Analysis on Thermal Efficiency of Non-Compressor Type Pulse Detonation Turbine Engines

Maeda, S., Kasahara, J., Matsuo, A., and Endo, T.

Transactions of the Japan Society for Aeronautical and Space Sciences 153 ( 181 ) 192-206 2010.11

Research paper (scientific journal), Joint Work, Accepted

爆発安全研究への期待

松尾亜紀子

RISS Newsletter : Safety & Sustainability 第8号  2010.09

Research paper (bulletin of university, research institution), Single Work

高エネルギーの放出が生む流体現象を解く

松尾亜紀子

火薬学会2010年度春季研究発表会  2010.05

Research paper (scientific journal), Single Work

Numerical analysis on behavior of dilute water droplets in detonation

Watanabe, H., Matsuo, A., Chinnayya, A., Matsuoka, K., Kawasaki, A., and Kasahara, J.

Proceedings of The Combustion Institute (Proceedings of the Combustion Institute)   2010

Research paper (international conference proceedings), Joint Work, Accepted,  ISSN  15407489

　View Summary

© 2020 The Combustion Institute Two-dimensional numerical simulations are conducted based on the Eulerian-Lagrangian method to model a gaseous detonation laden with monodispersed water droplets. The premixed mixture is a slightly diluted stoichiometric hydrogen oxygen mixture at low pressure. The outcome of the interactions of the droplet breakup with the cellular instabilities and the non-uniform flow behind the leading front is analyzed. The simulation results are also analyzed using instantaneous flow fields and Favre average profiles for water droplets. Breakup occurs mainly near the detonation front. The mean final diameter of the water droplets at the end of the breakup process is the same regardless of the initial strength of the leading shock or whether it is lower or greater than the Chapman-Jouguet value. The polydispersity comes from local phenomena behind the leading shock, such as forward jets coming from triple point collisions, transverse waves and a combination of both. The total breakup time is longer than that estimated from post-shock conditions and the present finding is in line with the previous experimental results on spray detonation.

• Access to Document (DOI)

Thrust Measurement of a Multicycle Partially Filled Pulse Detonation Rocket Engine

Kasahara, J., Hirano M., Matsuo, A., Daimon, Y., and Endo, T.

Journal of Propulsion and Power 25 ( 6 ) 1281-1290 2009.11

Research paper (scientific journal), Joint Work, Accepted

KHIにおける低公害航空エンジン燃焼器用燃料噴射弁の開発

小林正佳， 緒方秀樹， 小田剛生， 堀川敦史， 木下康裕， 松尾亜紀子

微粒化 (日本液体微粒化学会)  18 ( 61 ) 4-11 2009.03

Research paper (scientific journal), Joint Work

Numerical Investigation on Propagation Mechanism of Spinning Detonation in a Circular Tube

Sugiyama, Y., and Matsuo, A.

Proceedings of the Combustion Institute 32   2331-2337 2009

Research paper (scientific journal), Joint Work, Accepted

Matched Pressure Injections into a Supersonic Crossflow Through Diamond-Shaped Orifices

Tomioka, S., Izumikawa, M., Kouchi, T., Masuya, G., Hirano,K.,and Matsuo, A.

Journal of Propulsion and Power (AIAA)  24 ( 3 ) 471-478 2008.05

Research paper (scientific journal), Joint Work, Accepted

Numerical Analysis of Projectile-Launch Tube Wall Friction Effects on Projectile Acceleration in Single-Stage Gun

Miura, H., Matsuo, A.

Materials Science Forum 566   71-76 2008.01

Research paper (scientific journal), Joint Work

Interior Ballistics Simulation of the AGARD Gun Using Two-dimensional Axisymmetric Solid/Gas Two-phase Flow Model and Effectiveness of Simulation Method (in Japanese)

Miura, H., and Matsuo, A.

Science and Technology of Energetic Materials 69 ( 1 ) 8-15 2008.01

Research paper (scientific journal), Joint Work, Accepted

Multi-Dimensional Simulation on Ignition Stage of Granular Solid Propellant Varying Primer Configuration

Miura, H., Matsuo, A., and Nakamura, Y.

International Journal of Energetic Materials and Chemical Propulsion 7 ( 6 ) 507-522 2008

Research paper (scientific journal), Joint Work, Accepted

建物内部におけるガス爆発シミュレーション

MATSUO AKIKO

計算工学 12 ( 2 ) 1555-1562 2007.04

Research paper (scientific journal), Single Work

飛翔体加速装置における固体発射薬の燃焼シミュレーション

松尾 亜紀子，三浦啓晶

日本航空宇宙学会北部支部20周年記念講演会 (日本航空宇宙学会)   2007.03

Research paper (other academic), Joint Work

Comment on "Numerical studies on specific impulse of partially filled pulse detonation rocket engines" - Reply (Reply by the Authors to W. H. Heiser)

Matsuo, A., Endo, T., and Kasahara, J.

Journal of Propulsion and Power 23 ( 1 ) 254 2007.01

Research paper (scientific journal), Joint Work, Accepted

Unsteady Features on One-dimensional Hydrogen-air Detonations

Y. Daimon and A. Matsuo

Physics of Fluids (American Institute of Physics)  19 ( 11 )  2007

Research paper (scientific journal), Joint Work, Accepted

Numerical Analysis of Gas Explosion inside Two Rooms Connected by Ducts

Hashimoto, A., and Matsuo, A.

Journal of Loss Prevention in the Process Industries 20 ( 4-6 ) 455-461 2007

Research paper (scientific journal), Joint Work, Accepted,  ISSN  0950-4230

Homogeneous-Dilution Model of Partially Fueled Simplified Pulse Detonation Engines

Takuma Endo; Tomoaki Yatsufusa; Shiro Taki; Akiko Matsuo; Kazuaki Inaba; Jiro Kasahara

Journal of Propulsion and Power (AIAA)  23 ( 5 ) 1033-1041 2007

Research paper (scientific journal), Joint Work, Accepted

Numerical Studies on Specific Impulse of Partially Filled Pulse Detonation Rocket Engines

Sato, S., Matsuo, A., Endo, T., Kasahara, J.

Journal of Propulsion and Power 22 ( 1 ) 64-69 2006.12

Research paper (scientific journal), Joint Work, Accepted

Soot Track Generation in Mach Reflection (in Japanese)

Inaba, K., Matsuo, A., and Shepherd, Joseph E.

Journal of the Combustion Society of Japan 48 ( 146 ) 372-378 2006.11

Research paper (scientific journal), Joint Work, Accepted

A New Thermochemical Model for Numerical Simulation of Detonation (in Japanese)

Watanabe, K., and Matsuo, A.

Journal of the Combustion Society of Japan 48 ( 145 ) 281-292 2006.08

Research paper (scientific journal), Joint Work, Accepted